Products Contact Us Home RC SYSTEMS WIRELESS PRODUCTS ST-95 WIRELESS RELAY & REPEATER Offers our "Client/Server" FHSS (Frequency Hopping Spread Spectrum) interface in both 900MHZ and 2.4GHZ models Receives wireless broadcasts from up to 16 of our ST-48 wireless sensor transmitters and provides central display and alarm functions Includes four SPDT common alarm relays for driving local lights, horns or other alarm events ST-95 "Repeater" function retransmits ST-48 broadcasts. ST-95's may be designated Server/Repeater and located between ST-48 Sensor Transmitters and the final ST-71 or ST-90 Controller/Receiver Available in models suitable for Division 1 explosion-proof (shown at left) and Division 2 potentially hazardous areas Magnetic keypad for nonintrusive operation in potentially hazardous locations The ST-95 is designed to receive wireless broadcasts from a network of up to sixteen ST-48 wireless sensor transmitters. ST-48 monitored values and alarm status are indicated on the ST-95's front panel display. Four integral SPDT 5 amp alarm relays are available for driving strobes, horns and other alarm events. ST-95's are configured via the magnetic keypad so operator interface never requires opening the enclosure. Since ST-95's may be set as the wireless network's "server", no other controller is required by the network and a complete wireless network might be as simple as a single ST-48 and ST-95. A "repeater" function allows a mode where all ST-48 broadcasts are retransmitted by the ST-95. This repeater mode allows transmission distances be extended by locating an ST-95 between the ST-48's and the receiving ST-71 or ST-90 controller. ST-95's used as repeaters should also bet set as the wireless network's server since it will be physically closer to the ST-48's than the controllers. 8621 Hwy. 6 Hitchcock , TX   77563 Tel: 409-986-9800 Fax: 409-986-9880 Products | Contact Us | Home Copyright 2010 RC Systems Co. Inc. All rights reserved.